Printrbot LC Assembly

From Printrbottalk Wiki
Jump to: navigation, search

UNDER CONSTRUCTION!!

To build a standard size LC Printrbot, follow these instructions, in order. The parts fit together very tightly, and are difficult to take apart without damage.

Since the LC and PB+ are almost identical save for the base width, it may be helpful to look at the Printrbot LC+ Assembly instructions too.

CAD Files

If you are planning to print standard components with your LC, then you will need the STL files from Thingiverse.

Bill of Materials

LC Printrbot BOM

Official BOM on printrbot.com

Official Printed Parts List on printrbot.com

Preparation

At a minimum you will require the following tools throughout different parts of the build process. Specific steps below will indicate which tools are required, however it will be easiest to have them all on hand and easily accessible:

  • Side cutters (a.k.a. wire cutters or dikes)
  • Needle nose pliers
  • 2.5mm Hex wrench
  • Philips screwdriver
  • Ruler or some other accurate measuring device
  • Square
  • Light hammer or Vice
  • X-acto knife or other small razor blade

Construction Photos

Printrbot LC Photos

Base and Table (X, Y and Z assembly)

  1. LC Printrbot Base
  2. LC Printrbot X-axis
  3. LC Printrbot X-carriage
  4. LC Printrbot Y-axis

Extruder Sub-Assembly

  1. Extruder Motor
  2. Mounting Extruder
  3. Extruder Hot Tip
  4. Extruder Idler
  5. Extruder Gear Assembly

Electronics

  1. Hot Bed*
  2. Motors to Board**
  3. Applying Power to Board**


/* UNDER CONSTRUCTION, needing photos

/** BLANK


Return to Assembly