I kind of feel like someone on an island throwing a bottle in the water with a note hoping someone finds it but here goes.
I wanted to upgrade my hot end to a ubis 13S so I also purchased the G2 board. I admit I did not pay attention to the statement "for the brave tinkerer".
So long story short here is my problem I can't get it to work. I have tried Cura, Octoprint and Repetier. I can manually move the nozzle and get it to heat up and extrude. What I can't do is get it to home or print. When I try to home it does not stop just grinds the belt. I am confident there are people out there that have done this successfully. Any help, guidance or direction would be great. If I can't get this to run my only alternative is to tell my wife that I failed and need to buy a different board. That would not be an enjoyable conversation. Thanks in advance for any help you can give.