1) Is the UBIS 13HT (High Temp) hot end compatible with my Simple Metal with the Rev F4 board?
The PrintrBot site says you need the Rev F6 but I thought that might be just because that's the board they currently sell.
2) The other 'requirement' to use the UBIS 13HT is a firmware update: "Temperature sensor table must be updated for PT1000 w standard 4.7k ohm pull up"
but there's no indication as to where to get the updated firmware.
I've looked through the PrintrBot GitHub and I can only find what looks like the generic firmware for the Simple Metal.
Does anyone have a source for that firmware with the updated temp sensor table?
Thanks in advance
