This is a continuation of the "300mm No Sag" BUT for the 1405 Makers Simple version. viewtopic.php?f=21&t=6306&start=200#p49742
Files can be found over on Thingiverse: http://www.thingiverse.com/thing:372467
Based on the excellent modeling of the new kit from Threefer3 I have outlined some of the key points between the Simple models.
Z rod center distance spacing: 2014 Simple = 65mm / 1405 Makers Simple = 70mm
Y rod center distance spacing: 2014 Simple = 1405 Makers Simple = JL 300mm No Sag Mod = 70mm (same on all versions)
X rod center distance spacing: 2013 & 2014 Simple = 57.5mm / 1405 Makers Simple = 62mm
Z motor & ACME thread: Same location with respect to REAR Z smooth rod.
Front End: E3D will NOT fit.
Here are a couple work in progress mods to adapt to the 300mm No Sag:
I tweaked the front end to make room for an E3Dv5 so it is not exactly the same. The E3Dv6 may be too short, or you may be able to scoot it down in the mounting, somebody with one will have to confirm.
- Probe offset is 26mm
- Total of (3) fans. Extruder motor, Hot end, and Part.
- The fan mounts were quick and simple, so I gave the dimensions on the drawing to help if anybody wants to design their own.
- Cable management is not incorporated yet.
2014-06-20: Added rear mount that will work with all versions.2014-06-23
: Added short version of front end. Hopefully this will work better for E3Dv6 and Hexagon hot ends. Moved STL files over to Thingiverse.
You do not have the required permissions to view the files attached to this post.