Which Slic3r settings on PB Jr.
3 posts
• Page 1 of 1
Which Slic3r settings on PB Jr.
by Lemm » 2013-Aug-Tue-13-Aug
- 0
Printrbot Jr #11045
ACME TR10x2 Z Rod
GT2 Timing Belt with 20T aluminum pulleys
Octoprint + Raspberry Pi Wireless Printer Server
Printrbot Jr v1 -> v2 upgrade
http://www.thingiverse.com/Lemm
ACME TR10x2 Z Rod
GT2 Timing Belt with 20T aluminum pulleys
Octoprint + Raspberry Pi Wireless Printer Server
Printrbot Jr v1 -> v2 upgrade
http://www.thingiverse.com/Lemm
-
Lemm - ACME leadscrew
- Posts: 357
- Joined: 2013-Jul-Wed-09-Jul
- Location: Berlin, Germany
- Reputation: 24
Re: Which Slic3r settings on PB Jr.
by 508Parkour » 2013-Aug-Wed-20-Aug
When I first got my PB Jr. I wondered the same thing..... Here is the forum that I started:
viewtopic.php?f=16&t=2612
You should also check out the PB Getting Started Guide:
http://printrbot.com/wp-content/uploads ... Guide2.pdf
If you go to page 5 or 6, you can see the reccomended settings.
viewtopic.php?f=16&t=2612
You should also check out the PB Getting Started Guide:
http://printrbot.com/wp-content/uploads ... Guide2.pdf
If you go to page 5 or 6, you can see the reccomended settings.
- 0
- 508Parkour
- I'm an end stop.
- Posts: 73
- Joined: 2013-Feb-Tue-22-Feb
- Reputation: 2
Re: Which Slic3r settings on PB Jr.
by SilverFingers » 2013-Aug-Wed-20-Aug
I switched to Kisslicer with my PBJR, but I would also like to see someone's slic3r settings if they have it perfect.
- 0
Printrbot Jr v1
Bowden Extruder
M8 threaded rod
Heated Bed
Lots of mods
Printrbot Rules!
-
SilverFingers - Waiting for extruder temp...
- Posts: 99
- Joined: 2013-Jun-Sun-16-Jun
- Reputation: 2
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest