Page 1 of 1

Fresh Simple

PostPosted: 2014-Apr-Fri-10-Apr
by mummson
I just finished assembling my simple. :D

Am missing one 22mm screw the hardware store wont be open until tomorrow :( also the last pic shows some leftover parts. I triple checked and I am pretty sure I didn't miss any thing.

P1030229.JPG
P1030239.JPG
P1030244.JPG
P1030249.JPG
P1030251.JPG
P1030252.JPG
P1030253.JPG
P1030254.JPG
P1030255.JPG
P1030256.JPG
P1030257.JPG
P1030259.JPG
P1030260.JPG
P1030261.JPG
P1030262.JPG
P1030263.JPG
P1030264.JPG
P1030265.JPG

Re: Fresh Simple

PostPosted: 2014-Apr-Fri-11-Apr
by PxT
Nice job. I think the left over parts are common, better to have too many than not enough.

Re: Fresh Simple

PostPosted: 2014-Apr-Fri-11-Apr
by mummson
PxT wrote:better to have too many than not enough.


True, but I was missing one 22mm so I cant print :/

Re: Fresh Simple

PostPosted: 2014-Apr-Fri-15-Apr
by spitfirehauser
it all depends on what that 22mm screw went into? i can not think of many parts that would stop me from printing if only missing a single screw unless it was the one holding the hot end into the alum extruder...... :D

Re: Fresh Simple

PostPosted: 2014-Apr-Fri-16-Apr
by mummson
spitfirehauser wrote:unless it was the one holding the hot end into the alum extruder...... :D


Bingo!