Configuration.h for Printrbot Jr. Available Somewhere?

Configuration.h for Printrbot Jr. Available Somewhere?

Postby jkao » 2013-Jun-Thu-01-Jun

I'm getting ready to try my hand at flashing my Printrbot Jr. with custom firmware (to try PxT's updated leading-edge Marlin merge and different extruders that may require me to invert the E direction).

To save time in experimenting with all the settings I need for the Printrbot Jr., is the Configuration.h for it available somewhere? In the stock PxT/Marlin repo, I can find the complied binary version of the PBJuniorFirmware, but the Configuration.h seems to be for one of the other printrbots.

Thanks!
  • 0

jkao
Waiting to connect to printer...
 
Posts: 2
Joined: 2013-Jun-Mon-09-Jun
Reputation: 0

Configuration.h for Printrbot Jr. Available Somewhere?

Sponsor

Sponsor
 

Re: Configuration.h for Printrbot Jr. Available Somewhere?

Postby PxT » 2013-Jun-Thu-10-Jun

I asked Brook a long time ago to provide the source tree that was used to build PBJuniorFirmware.hex but he never did. I think the only change is that the Y direction is inverted (flip the state of the INVERT_Y_DIR option) but I'm not 100% sure.
  • 0

User avatar
PxT
Print complete...
 
Posts: 1339
Joined: 2011-Dec-Mon-16-Dec
Location: Sacramento, CA
Reputation: 97

Re: Configuration.h for Printrbot Jr. Available Somewhere?

Postby jkao » 2013-Jun-Thu-20-Jun

Ok, I'll play around with it then, and if I find something that works, I'll post what I end up using.

Thanks!
  • 0

jkao
Waiting to connect to printer...
 
Posts: 2
Joined: 2013-Jun-Mon-09-Jun
Reputation: 0


Return to General

Who is online

Users browsing this forum: No registered users and 1 guest

cron