Michele31415 wrote:Hmm - so if I have a 3 mm. hotend, does this mean I can also run 1.75 mm. filament through it?
Michele31415 wrote:Hmm - I just noticed that on Printrbot's web site, they give the specs for the Printrbot+ (here: http://printrbot.com/support/printrbot-plus/) as "Hot End: Ubis 1.75mm, 3mm". But it's not clear itf they mean you can get a hot end with one of two different sizes or if the one hot end can use both sizes.
Users browsing this forum: No registered users and 1 guest