Page 1 of 1

Printrbot hot end, temperature sensor connectors

PostPosted: 2019-Jan-Wed-13-Jan
by accuprintr
I have a thermistor cable which has multiple breaks in it from being worn out. I was thinking of making a new cable, but I am unable to find connectors which are used by printerbot. Were they originally sourced from digikey? Is it possible to buy them on Amazon or eBay?

Re: Printrbot hot end, temperature sensor connectors

PostPosted: 2019-Jan-Wed-14-Jan
by RetireeJay
This thread should give you all the info you need:
viewtopic.php?f=21&t=4567