Need: wiring harness for auto-leveling sensor

Need: wiring harness for auto-leveling sensor

Postby Joymaker » 2019-Jun-Tue-17-Jun

A while back I was replacing the auto leveling sensor in my Simple Metal, and I let the wrong wire touch the wrong surface. There was a flash, and a bit of smoke coming from somewhere, it seemed to be the wiring itself. Apart from that sensor, the main board seems to work fine, responds in all the right ways. Getting yet another auto leveling sensor didn't fix things. I have been led to believe that the problem is probably in the "wiring harness" that connects that sensor among other things, and that wiring harness contains a resistor.

I need to repair or replace this. Need my printer back in order! If anyone can:
1. Sell me one off your defunct printer
2. Tell me some detailed specs on how I might make the repair
please let me know, I would much appreciate it.

Or
3. If you can tell me how to convince my printer to run even in the absence of that sensor, that would also be useful.

Thanks to all,
Ken
  • 0

Joymaker
Loading filament...
 
Posts: 23
Joined: 2014-Dec-Wed-22-Dec
Reputation: 0

Need: wiring harness for auto-leveling sensor

Sponsor

Sponsor
 

Return to General

Who is online

Users browsing this forum: No registered users and 1 guest