Looking for Z Cable from Probe to motherboard

If you need a printed part, post here and hopefully someone will oblige. Be sure to post your location (city, state/province, country)

Looking for Z Cable from Probe to motherboard

Postby Radioman1017 » 2015-Apr-Sat-16-Apr

Hello all,

I'm looking to replace the 3-wire male-female connector that runs from the printrboard to the white connector on the Z probe. It looks like an arduino connector. Does anyone know where I can get it?

Thanks,

Mark
  • 0

Radioman1017
Waiting for printbed temp...
 
Posts: 121
Joined: 2014-Dec-Fri-20-Dec
Reputation: 4

Looking for Z Cable from Probe to motherboard

Sponsor

Sponsor
 

Re: Looking for Z Cable from Probe to motherboard

Postby frankv » 2015-Apr-Sat-16-Apr

When I replaced my Z-probe, I used a standard 0.1" female header connector on the new one. This was on a Rev D board. Just have to be careful plugging it in to ensure you get the right orientation.
  • 0

frankv
First blob a success!
 
Posts: 519
Joined: 2015-Jan-Thu-12-Jan
Reputation: 18


Return to Need a part

Who is online

Users browsing this forum: No registered users and 1 guest