Page 1 of 1

Would someone be willing to print some things for me?

PostPosted: 2015-Feb-Mon-17-Feb
by Vapor
I'm sorry if this is the wrong forum, but wasn't sure which place to put it. Please move if it needs to be somewhere else.


I'm needing someone (I'll pay) to print some wooden simple parts. I'm needing a z probe holder and extended X bed ends. I apparently didn't use enough fill when I did the ones I've got an over time they've started to sag. I'm having trouble getting any descent prints right now.

Does anyone have any free time and want to make some of these for me? ABS?? Any color would work?


PM me please if you've got the time and desire!

Thanks a million.

Re: Would someone be willing to print some things for me?

PostPosted: 2015-Feb-Mon-18-Feb
by orangefurball
What parts do you need exactly?

For future reference, this can be placed in the "Need a part" subforum!

Re: Would someone be willing to print some things for me?

PostPosted: 2015-Feb-Mon-18-Feb
by PxT
[mod note: moved to appropriate sub-forum]

Re: Would someone be willing to print some things for me?

PostPosted: 2015-Feb-Mon-18-Feb
by evanalmighty
Let me know if you need help.

Re: Would someone be willing to print some things for me?

PostPosted: 2015-Feb-Mon-22-Feb
by Vapor
Evan, will do!

Where the heck is the "need a part" subforum. I'll go look again. I promise I looked, I promise! :)

Re: Would someone be willing to print some things for me?

PostPosted: 2015-Feb-Mon-22-Feb
by PxT
Vapor wrote:Where the heck is the "need a part" subforum. I'll go look again. I promise I looked, I promise! :)


You're already in it because I moved this topic earlier. It's at Board index ‹ Hardware & mechanics ‹ Need a part