Ubis hot end

If you need a printed part, post here and hopefully someone will oblige. Be sure to post your location (city, state/province, country)

Ubis hot end

Postby ElmoC » 2014-Dec-Wed-09-Dec

I just had a print go terrible wrong and as a result, filament got pushed up so far under the insulating sleeve it severed the wire to the heating coil. Printrbot is out of stock on all their hot ends. Does anyone have a spare they would be willing to sell?
  • 0

ElmoC
Loading filament...
 
Posts: 15
Joined: 2014-Dec-Mon-17-Dec
Reputation: 1

Ubis hot end

Sponsor

Sponsor
 

Re: Ubis hot end

Postby evanalmighty » 2014-Dec-Wed-11-Dec

Now is a good time to look into E3D or other hotends. I'll never use Ubis hotends again.
  • 0

User avatar
evanalmighty
Layer 650 of 1234
 
Posts: 689
Joined: 2014-Feb-Mon-15-Feb
Location: Irvine, CA
Reputation: 45

Re: Ubis hot end

Postby ElmoC » 2014-Dec-Wed-11-Dec

What does it take to switch? I had thought about switching to another hot end but hadn't investigated what it takes to mount one and what changes to the controller is needed. You have any links or suggestions about it?
  • 0

ElmoC
Loading filament...
 
Posts: 15
Joined: 2014-Dec-Mon-17-Dec
Reputation: 1

Re: Ubis hot end

Postby musk » 2014-Dec-Wed-12-Dec

You could also fill out a support ticket with Printrbot to see if they'll fulfill an order through there.
  • 0

Printrbot Metal Plus (2x)
Printrbot Simple Metal (2x)
musk
Solid infill...
 
Posts: 215
Joined: 2014-Aug-Sun-22-Aug
Reputation: 23

Re: Ubis hot end

Postby ElmoC » 2014-Dec-Wed-12-Dec

musk wrote:You could also fill out a support ticket with Printrbot to see if they'll fulfill an order through there.


Already did. Still waiting to hear from them.
  • 0

ElmoC
Loading filament...
 
Posts: 15
Joined: 2014-Dec-Mon-17-Dec
Reputation: 1


Return to Need a part

Who is online

Users browsing this forum: No registered users and 2 guests

cron