Ubis hot end 3mm

If you need a printed part, post here and hopefully someone will oblige. Be sure to post your location (city, state/province, country)

Ubis hot end 3mm

Postby rho-wan » 2014-Sep-Fri-14-Sep

Hello, I would like to buy a Ubis hot end for 3mm filament but I cannot find it on the store.
Any idea where to find it?

Thanks.
  • 0

PrintrBot LCv2 and ABS. Flipped PCB with alu 3mm plate and then kapton on top, plus hairspray. Three paper rings ("frames") between PCB and alu plate, to compensate for the bulging PCB when warm.
Sunflower oil between PCB and alu plate to try to improve heat conduction (better than air anyway!)
rho-wan
Waiting for printbed temp...
 
Posts: 105
Joined: 2013-Jul-Fri-01-Jul
Reputation: 3

Ubis hot end 3mm

Sponsor

Sponsor
 

Return to Need a part

Who is online

Users browsing this forum: No registered users and 1 guest

cron