Printrbot simple part needed

[bluetape66]

When I was first putting my simple together I was nearing the end of the build processes when I got stuck trying to place the first base plate of the bed on, and started trying to hammer it in. (please don't look down on me too much, it was late and I was getting frustrated.) This dented then piece but only on one side now the bottom plate has a severe slant in it, and has been giving me a few issues, I was wondering if anyone had a spare piece or could print me one.

I live in Delaware and can pm you my address, sadly I don't have a credit card or a paypal (DAMN YOU AGE! *shakes fist wildly in air) but I could mail you a few dollars!




Part number 2

[Node7Elec]

If it were a smaller part i would happily print it for you but i cannot print parts that big and do not have access to a laser cutter.

[rotus8]

I believe this part will be left over after an XL upgrade. Whenever my kit shows up you can have that piece as I will be building the XL from the start.

[evanalmighty]

OP if you still need this part I have it. I just bought my Simple and the XL upgrade at the same time so that part isn't needed for my build.