Page 1 of 1

Taulman Spool Webbing

PostPosted: 2017-May-Mon-14-May
by ktfergus
Last week, I was noodling around on the Taulman website when I came across this page. I've been printing with various Taulman products for nearly two years & never realized you weren't supposed to remove the mesh/webbing on their small spools.

I just wanted to post this so no one makes the same silly mistake...

-Kelly

Re: Taulman Spool Webbing

PostPosted: 2017-May-Mon-14-May
by RetireeJay
I've been taking it off too!

Re: Taulman Spool Webbing

PostPosted: 2017-May-Mon-14-May
by Mooselake
I think PxT told me to keep it on, although it might have been Dr. Google

Kirk

Re: Taulman Spool Webbing

PostPosted: 2017-May-Tue-10-May
by PxT
Haha, oops. Don't think it was me because I've been taking it off. This has got to be a pretty common "mistake". I mean it's not even really a mistake because obviously people have been able to print just fine without the webbing.