fan - structural problems

Discuss your first ever printrbot print

fan - structural problems

Postby EyKi » 2015-Apr-Wed-09-Apr

Hey guys, i just got my printrbot simple metal, put everything together and it worked, i finished the two 3mm cubes and now went on to the fan
my settings are still not good
what are (for you) obvious settings that arent fine yet? i have to lower my z-probe a bit again i think, but other than that...
it feels like the pla is not printing thick enough and the socket of the thing also is very thin
also the bed wasnt prepared perfectly... i got a tape but it doesnt seem to be as good as the blue one most of you use

what do you guys see? =)

here is the fan:
  • 0

You do not have the required permissions to view the files attached to this post.
EyKi
Waiting to connect to printer...
 
Posts: 2
Joined: 2015-Apr-Wed-08-Apr
Reputation: 0

fan - structural problems

Sponsor

Sponsor
 

Re: fan - structural problems

Postby DonaldJ » 2015-Apr-Thu-06-Apr

What are your settings (speed, layer height, temperature, etc.)? Was cooling enabled?
  • 0

DonaldJ
Support material...
 
Posts: 498
Joined: 2012-Aug-Mon-04-Aug
Location: Chicago IL
Reputation: 29

Re: fan - structural problems

Postby EyKi » 2015-Apr-Thu-07-Apr

hey
i dont remember the exact settings for this one, but i printed out some others and i think im getting closer to a good setup =)
the only thing i remember is: fan was on, speed was on standard ...

newest print below (right)
pretty close to "good" settings i think
  • 0

You do not have the required permissions to view the files attached to this post.
EyKi
Waiting to connect to printer...
 
Posts: 2
Joined: 2015-Apr-Wed-08-Apr
Reputation: 0


Return to My first blob

Who is online

Users browsing this forum: No registered users and 3 guests