Page 1 of 1

Simple metal printed fine yeaterday, and then......

PostPosted: 2015-Mar-Wed-22-Mar
by SteveS
Hi all, I got my bot yesterday, spent a lot of time to get it setup, printed a couple of items, everything was fine after I got it dialed in. This morning, I went to print a spool holder, and here is what happened.

image.jpg


I had to go back and repeat the setup, before it would print properly. My hotend temp was 210c, hotbed temp 60c, using sample pla I got with printer, print speed 50, same as yesterday.

Any ideas, or did I not supply enough, info.

Thanks in advance, really am enjoying 3D printing.

Re: Simple metal printed fine yeaterday, and then......

PostPosted: 2015-Mar-Wed-14-Mar
by SpannerHands
Maybe you did not save the settings with the M500 Command? I have done this before as soon as you power off it goes back to the last saved settings...