simple cube in action.

Discuss your first ever printrbot print

simple cube in action.

Postby ThereWillBprints » 2014-Feb-Mon-00-Feb

I am not going to lie. It took my a while to figure out I had the smaller nut and bolt on there. I also am not using their filament. My settings were the suggested but I went with 200 degrees. Which was okay at first then it got ulgy. Oddly enough "stella," as I call her, got self corrected some how and started printing the cube at an angle. I do not though know how all the rest happened.

In the name of humor though, my first print was red balls. Lol.
  • 0

You do not have the required permissions to view the files attached to this post.
406mm by 8mm lm rods for x and z axis
Z stabilizer bar
bearing plates printed for fabricated plexi glass print bed (8"×18")
New print are a 274 mm width × 267mm height × 101 depth (will change to 200 mm once verified and I have time)
ThereWillBprints
Waiting for printbed temp...
 
Posts: 102
Joined: 2014-Feb-Fri-02-Feb
Reputation: 9

simple cube in action.

Sponsor

Sponsor
 

Return to My first blob

Who is online

Users browsing this forum: No registered users and 1 guest

cron