Page 1 of 1

First Run From PB Simple

PostPosted: 2014-Feb-Thu-18-Feb
by JeffM
IMG_0076.JPG

First Cube that we tried to print, had some heat and feed issues and it ended up coming apart like frosted wheat.

IMG_0072.JPG

Second cube had a bit too much feed at the start but after adjustments it came out pretty good.

The string based X and Y axes are a bit fiddly and a pain to assemble but OK once they get going, but right now it's printing parts for the belt X and Y upgrade :)

Re: First Run From PB Simple

PostPosted: 2014-Feb-Fri-07-Feb
by WayTooManyHobbies
It's a good start, particularly to see something improve so much in a short time.