This is a Z-Axis effect. It's frequently caused by math. Really.
RetireeJay has done a fantastic writeup of this issue: http://www.printrbottalk.com/forum/viewtopic.php?f=20&t=4596&hilit=ribbing
It's not impossible that it's mechanical, if the z threaded rod is wobbling badly, that could be the cause, but read the post above for the most likely cause.
(optional Dual Extrusion) Printrbot Plus V1 [3/2013]
bed stabilizers, bed levelers, Y & X belt tensioners,
50mm fan mount, LED ring light, Z-axis screw Isolators,
Z-shaft stabilizers,optional Bowden conversion, GT2 belts/pulleys,
M8x1.25 Z Screws, Flex. Z-couplers,
RAMPS 1.4 w/ LCD,
Quick Change Extruders:
Option 1- Dual hybrid geared Wade's/Bowden w/ 3mm & 1.75mm Ubis,
Option 2 - Dual direct geared Wade's w/ 3mm & 1.75mm Ubis
Option 3 - Single geared Wade's w/ 3mm or 1.75mm Ubis
Option 4 - Single belt drive Wade's w/ E3D
MIC-6 metal bed
Thingiverse Profile: http://www.thingiverse.com/tdeagan/designs