So got my new Printrbot Metal Simple last night, and was really happy with my first few prints. Yeah there might have been a couple stops and restarts.
But the thing that was causing me the most problems was the all the prints where starting off in the back right corner of a bed? Which I totally didn't get, because the test print that the folks at Printrbot did and was smack dab in the middle of the bed when I un-boxed it? so i started playing around with the M212 code and moving my x and y closer to the center and saving them to the config with M500. but if Printrbot had printed in the center of the bed, why would I have to set x and y again? Or is some setting I missed in CURA?
If anyone else has seen this, would love to find out more from you.
Thanks
Russ