Bats1939 wrote:Can I point out that a lot of threads about "simple" problems are handled with "there's a lot of threads on X, I suggest you search." And when you search for X you just get all those threads instead of the relevant ones that will answer the damn question?
Place + in front of a word which must be found and - in front of a word which must not be found. Put a list of words separated by | into brackets if only one of the words must be found. Use * as a wildcard for partial matches.
Bats1939 wrote: I have been chasing the answer to how I clean my nozzle for a few hours now, finally found a thread that sounds like it'll describe it and it ended with, "I suggest you look for a thread that talks about changing the nozzle."
Which I still can't find a thread on.
Bats1939 wrote:"Sorry Mario, but your princess is in another castle" is just as frustrating now as it ever was. Can we get some more newbie problem stickies without resorting to acting out the IT Crowd?
SilverFingers wrote:Yeah I know. I wish there was better/faster customer support sometimes.
SilverFingers wrote:I still can't find out how to print from my damn SD Card.
SilverFingers wrote:Btw to clean your nozzle I'm pretty sure you unscrew it and soak it in acetone for a few hours. I thought mine was clogged but it was only the extruder, so check that too.
Bats1939 wrote:I didn't think to do -search, that's a good idea.
I managed to get the nozzle off. All I wanted to know, which was in that thread thanks!, is whether or not I would be damaging the wires or assembly if I removed it, and where to grab it with my wrench since only the nozzle is visible under the red jacket. Sadly, the jam seems to be in the upper part of the extruder, about 45mm above the nozzle. I can't figure out how to take the extruder off to work on it tho. My printrbot is pre-assembled, so the thought of taking it apart scares the crap out of me. I've broken enough important things to be more cautious and get as much information as possible on the problem before attacking it with a wrench.
allanonmage wrote:Everytime i come across support via IRC I'm like "ugh who actually uses IRC? Didnt that die already?"
Users browsing this forum: No registered users and 1 guest