anyone know a second source for Ubis Hot End in the PrintrBot configuration? I need to acquire a new Ubis Hot End. The printrbot.com store is listing them as out of stock. I am planning on experimenting and don't want to mess up my "good" hot end.
Alex
Ubis Hot End
9 posts
• Page 1 of 1
Re: Ubis Hot End
by Crusader » 2012-Jul-Tue-17-Jul
Do anyone know where I can find the Ubis Hot End Building Plan?
With the exact names of all Items used?
If the plan isn't complete, I will draw the plan, but I need all little details!
Would be very great, if we share the knowledge to all!!
With the exact names of all Items used?
If the plan isn't complete, I will draw the plan, but I need all little details!
Would be very great, if we share the knowledge to all!!
- 0
-
Crusader - Waiting to connect to printer...
- Posts: 3
- Joined: 2012-Jul-Tue-14-Jul
- Location: Germany, Düsseldorf
- Reputation: 0
-
scantrontb - Can update firmware
- Posts: 825
- Joined: 2011-Dec-Sun-14-Dec
- Location: federal way, wa
- Reputation: 5
Re: Ubis Hot End
by k1nc81d » 2012-Jul-Fri-00-Jul
You can just buy the hotend from the printrbot store. Looks like they have 73 in stock. I talked to Brook earlier. He said he is shipping the parts listed on the store. He's just not shipping any kits till the backers get theirs.
- 0
- k1nc81d
- Printing skirt...
- Posts: 170
- Joined: 2012-Jun-Thu-17-Jun
- Reputation: 0
Re: Ubis Hot End
by jr57k » 2012-Aug-Wed-12-Aug
out of stock again. I NEED a hot end to go in my wooden extruder!
- 0
- jr57k
- Layer 300 of 1234
- Posts: 320
- Joined: 2012-Apr-Sat-18-Apr
- Location: Augusta, GA
- Reputation: 0
Re: Ubis Hot End
by drawcut » 2012-Aug-Wed-17-Aug
- 0
Printrbot original. Major mods: Y axis extended to ~8", Z extended to ~8.5". 5mm SS Z threaded rods w/ flex couplings. E3D hotend. Purchased Acetel gears. Glass bed with Elmers' purple glue stick for most prints. Top of Z axis rods have added cross structure similar to a Prusia i3.
-
drawcut - ACME leadscrew
- Posts: 386
- Joined: 2012-Mar-Mon-19-Mar
- Location: USA - Wisconsin
- Reputation: 16
Re: Ubis Hot End
by beisemann » 2014-Jan-Wed-15-Jan
Any new developments in this? I just had one of the wires break off my hot end. And the PrintrBot store is out of stock. Going to attempt a repair... but wanted to get one ordered if I can help it.
- 0
- beisemann
- Waiting to connect to printer...
- Posts: 5
- Joined: 2013-Dec-Tue-13-Dec
- Reputation: 1
9 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest