vdubskey wrote:After looking at your spread sheet closer your physical EXP2 pin numbers are different from the way the eagle .brd file has them listed. In the picture I have attached, pin number 1 starts on the top right and goes left and pin 8 would be the bottom right. So I decided to try out how I think you have them listed, counting the number 1 pin on the top right, then pin 2 below that and so on. Now I don't get any yellow blocks at all, just blank. Can you explain how you have your physical EXP2 pin numbers listed? I'm starting to think there are settings somewhere else in the firmware that need to be altered. I have #ULTRALCD and #UTILPANEL enabled in config.h and have the pins in my first post entered in the pins.h. Not sure what else to look for.
vdubskey wrote:Yes, as I said in my last post I have tried hooking it up exactly as you just posted and get nothing, blank. I'll have to look elsewhere in the firmware for the culprit or troubleshoot the LCD itself if that's the case its not working. Thanks for your help.
Users browsing this forum: No registered users and 2 guests