Metal Plus and G2 board

Talk about modifications to the printer

Metal Plus and G2 board

Postby trathier » 2017-Oct-Thu-10-Oct

I purchased the G2 upgrade board at the beginning of May along with the 4-start z lead screws, gear head extruder, fan upgrade, LED bar, and Ubis 13s hot end. When everything is installed all I can get it to do is light the LEDs. I am trying to flash the firmware with a 2017 Mac pro with touchbar, but the mac won't recognize the connected printer. This would go much easier with a windows solution but I haven't found one.

Ideas?
  • 0

----------------------------------
Printrbot Metal Plus
Single extruder
Heated bed
4-start lead screw upgrade
Ubis 13s hot end
Gear head Extruder
G2 processor
----------------------------------
MatterControl Touch 2nd Generation
trathier
Waiting to connect to printer...
 
Posts: 8
Joined: 2015-Oct-Wed-08-Oct
Reputation: 0

Metal Plus and G2 board

Sponsor

Sponsor
 

Return to Mod talk

Who is online

Users browsing this forum: No registered users and 2 guests