Klipper 3D LCD?
4 posts
• Page 1 of 1
Klipper 3D LCD?
by YellowGTO » 2019-Dec-Sat-10-Dec
Has anyone gotten the LCD to work with Klipper 3D firmware? I can't figure out the pin out.
- 0
- YellowGTO
- Printing skirt...
- Posts: 159
- Joined: 2013-Dec-Wed-12-Dec
- Reputation: 8
Re: Klipper 3D LCD?
by Mooselake » 2019-Dec-Sat-13-Dec
Klipper was discussed here a couple years ago, with no mention of successful implementations (Printrbot or others), and nothing about LCDs. Sorry
There seems to be active Klipper site , might be worth a look.
Personally I'd be looking at something like an E3 mini and not trying to deal with Klipper. Around a third the initial printrboard price, and half the post shutdown price, for a lot more capability, with the added bonus of TMC drivers. Hard to beat, less than a cased and powersupplied Pi. There's somebody on the Printrbot FacePlant group talking about supplying an adapter kit, too
Kirk
There seems to be active Klipper site , might be worth a look.
Personally I'd be looking at something like an E3 mini and not trying to deal with Klipper. Around a third the initial printrboard price, and half the post shutdown price, for a lot more capability, with the added bonus of TMC drivers. Hard to beat, less than a cased and powersupplied Pi. There's somebody on the Printrbot FacePlant group talking about supplying an adapter kit, too
Kirk
- 0
Modified KickStarter Classic Plus 7/2012
KS Thingybot Delta Pro 10/31/16
Creality Ender 3 Pro 12/2019
KS Thingybot Delta Pro 10/31/16
Creality Ender 3 Pro 12/2019
-
Mooselake - My next printer is...
- Posts: 3625
- Joined: 2011-Dec-Tue-23-Dec
- Location: Moose Swamp, Upper Michigan, USA
- Reputation: 177
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest