Metal Plus Noise reduction - Dynamat

Talk about modifications to the printer

Metal Plus Noise reduction - Dynamat

Postby ururk » 2017-Feb-Wed-17-Feb

I haven't done this to my machine at home, but we got a small roll (of Dynamat Extreme, with more goodness, I suppose) for the office machine and it reduced the harshest frequencies quite a bit. I don't have proper sound equipment, but I took some audio recordings before and after and it was a marked improvement.

Basically, I installed it in the two pillars - 9" x 13.5" pieces, as well as inside the bottom and the larger piece that attaches to the print bed rails.

Just curious if:

Anyone else has tried this?
Any methods to quiet down the servos?

I've read a little about reducing the voltage in the firmware, but for a stock printrbot, is this worth the effort?
  • 0

http://pxstl.com: pixel to stl...
ururk
Levelling print bed...
 
Posts: 25
Joined: 2014-Dec-Fri-16-Dec
Reputation: 0

Metal Plus Noise reduction - Dynamat

Sponsor

Sponsor
 

Return to Mod talk

Who is online

Users browsing this forum: No registered users and 2 guests