Problem with g-code by repetier

Troubleshooting talk for software

Problem with g-code by repetier

Postby Mais » 2015-Mar-Mon-11-Mar

We bought a 1401 for a high school printrbot 1401(Printrbot simple bill is dated February 26, 2014) . (Printboard rev D)
I use to control the repetier V1.0.6.The printer connects correctly.
Problem: I can move X, Y and Z with manual controls but for the Z axis when I order a displacement of 10 mm for example, it goes a little distance up then
descends and lands on sensor Z. If I change displacement value the problem remains the same (the distance does not change).
When I want to send the g-code manual with repetier, the printer never moves.
If I send M119 software does not return any information.
What do you think of this? thanking you in advance.
  • 0

Mais
Waiting to connect to printer...
 
Posts: 1
Joined: 2015-Mar-Thu-09-Mar
Reputation: 0

Problem with g-code by repetier

Sponsor

Sponsor
 

Return to Troubleshooting talk

Who is online

Users browsing this forum: Bing [Bot] and 2 guests

cron