which printrbot simple do i have?

[bobbas41]

hi guys, I just picked up a printrbot simple from a freind, and when i go through the setup in cura theres a bunch of simple options to choose from. If I choose simple, when going through the bed leveling wizard it thinks my bed is much smaller than it actually is. When I choose plus v.1 the table size is correct and everything works except the heater bed, this model has a heater under the bed. Can anyone tell just by the pics which machine i need to select in cura to get my heater bed working? Can you modify Gcode in cura? I could just add the Gcode to the start and end but i dont see a place in cura where it will let you make changes to the gcode?

[AZBotr]

Give "Printrbot Simple Metal" a try - that should get you going...

[bobbas41]

thanks, it ended up wanting plus v.1 140501 to get the heated bed to work, its working thanks.

[IB3D]

Which version of Cura are you using?