by RetireeJay » 2017-Jun-Sat-09-Jun
Yes, that should work. The 12V specification is actually fairly loose on the up side, so a fully charged lead-acid battery at 14.5V is no problem. The Hot End draws about 40 watts, and probably everything else doesn't add up to more than another 40 watts, as long as you don't have a heated bed. Thus, 80 watts at 12V = 6.7 amps, meaning one battery could theoretically provide power for about an hour. If you connect the battery in parallel with your mains supply, then this would give you a chance to finish a small print or initiate an orderly shutdown if you have a large print in process. Perhaps a very good idea if you are in an area where the mains supply is unreliable. If you think this will be a frequent occurrence, I'd strongly suggest getting one of those very cheap digital voltmeters so you can monitor the voltage and shut down the printer when the battery drops below 11 volts or so. (Mooselake has posted about very cheap voltmeters).
Printrbot Plus operational January 2013
Brass threaded rods (5/16" X 18) & nuts for Z axis
GT2 belts & pulleys
Cable chain to reduce probability of fatigue failure in wires
E3D V5 Hot End, 0.4mm nozzle, also 0.8 and 0.25 in use occasionally
PB fan mount + 40mm fan -- using printed mount adapter, not the E3D supplied fan
Injection molded extruder gears
Optical Z "endstop" (custom designed and built)
Have used many pounds of T-Glase filament. Now also doing some work with Ninjaflex SemiFlex
Print on glass with Scotch Craft Stick or other glue stick
"My next printer is..." Prusa i3 MK3, upgraded to MK3S