lwalkera wrote:Hi, I designed the printrboard. Here are the connectors you need:
For all, the metal crimps: http://search.digikey.com/us/en/product ... 4-ND/26475
4-pin housing: http://search.digikey.com/us/en/product ... 2-ND/26435
3-pin housing: http://search.digikey.com/us/en/product ... 1-ND/26433
2-pin housing: http://search.digikey.com/us/en/product ... 0-ND/26431
If you have any further technical questions with the electronics, don't e-mail Brook, just contact me.
danimal1228 wrote:I realize this is an old thread but it has some really good info.
The connectors that connect the extension wires to the extruder heater & thermistor are "Molex Micro-Fit" 3.0 connectors. You will need 2 complete sets, 1 for the thermistor & 1 for the extruder heater.
A complete set is (Molex):
1x #43645-0200 "Receptacle"
2x #43030-0007 "Female Socket"
1x #43640-0201 "Plug"
2x #43031-0007 "Male Pin"
While we are at it, I know that there are links to the other connectors but I figure I would list them & their part numbers here too. They are Molex KK 0.100" connectors:
6x #22-01-3047 "4 for the motors, 1 for the extruder heater & 1 for the hot bed"
4x #22-01-3037 "3 for the XYZ endstops & 1 extra. ??"
3x #22-01-3027 "2 for the thermistors & 1 for the fan"
All of them can be found on Mouser, Jameco or digikey.
rswarner wrote:Very sorry. It was lame of me not to explain in my post that I pulled that wire after the fact, as I started dissecting the connector.
Users browsing this forum: No registered users and 1 guest