Logic board for Printrbot Metal Plus 1504

[accuprintr]

I need a new logic board for Printrbot Metal Plus 1504. I found geetech board online, but it's old revision - D. Can anyone point me to the site which sells replacement boards?

[cbxbiker61]

I have both a PrintrBoard F4 and a PrintrBoard F5 which are fully functional. I will sell either of those boards.

[foster]

If OP isn’t interested in the F5, I am - if you think it would get my Simple Pro up and running. You gave me some good advice about the Einsy. Main goal is to get my bot printing again and if using the F5 would work and save some effort converting, that would be nice.


Sent from my iPhone using Tapatalk

[cbxbiker61]

Foster, I'll PM you with details on the F5.

[ElvinStrawhat]

The updated 1504 model has updated metal parts including, but not limited to increased support for the extruder motor wiring, access to the Printrboard reset button, and a sweet “PB” logo on the back of the print bed.

[Caribou_Jim]

My Rev 5 Printrboard has fried something that runs my 12v input. The bed doesn't receive power, the hot end doesn't receive power, and the Z-Probe don't, but my fans do.

I've poked and prodded with my multimeter trying to trace where the faulty component is, but I'm worried it's the CPU. At this point, I'm looking to just replace the board. But, like OP said, only the Rev D's are available online, and the only Rev 5's I can find only ship to Costa Rica. What options are there for getting a new board?