If this isn't where this post should go, I apologize. I'm not finding the info I'm looking for, but I'm sure it's here somewhere.
I put some z probe firmware on my old wooden simple a long time ago. I've been meaning to update it forever but just haven't done it.
Today I'm changing out some parts and am having to recalibrate my z probe.
The firmware I put on it so long ago was one that had the 9 point z leveling instead of the normal 3. (I don't know why). It's a wooden simple, but the Y limit switch is on the front near the extruder instead of the back like stock. (once again, I'm not sure why.)
Anyhow, now that I'm updating other things, I want to go back and put new firmware on.
I've been looking and can only find one listed on the git. Is it a unified firmware? Will I have to go in and edit it to show where the stop switches are?
I'm feeling pretty brain dead and things just aren't making sense to me.