Hi,
Hopefully there's at least one other Crawlbot owner here who might be able to help me... I've set up my Crawlbot and am trying to cut the PB logo test, but I'm running into issues. The Crawlbot cuts the first hole in three passes, but when it moves to cut the second hole the router isn't lifting up at all, so it's cutting through the plywood (all 3/4" of it) in one pass, when it's not supposed to be cutting at all. Then it moves on to cut the logo, still without retracting at all.
I've followed the setup instructions, lowered the router down until the bit makes contact with the work surface, zeroed all axis, then run the sample gcode.
If anyone has any suggestions I'd greatly appreciate it. I've tried numerous times now with the same results.
Thanks,
Vince