- New Printrbot Metal Plus, never printed anything with it
- Heated bed factory option newly installed
- Dual extruder factory option newly installed
- Dual extruder firmware newly flashed
- Extruders leveled, per PB instructions
- Bed sensor adjusted, per PB instructions
- Repetier Host software being used, only for manual control so far
Looking at the manual controls, there is an X-Y plane movement button-circle, that has individual home buttons outside it for (CW from upper left) X, Y, Z, and ALL.
After carriage is moved to random [X, Y, Z], press Home-All
Result:
- Carriage executes a simultaneous Home-X and Home-Y (arriving at upper left of bed)
- Carriage immediately moves to ~[90,127,current-Z] and begins to step down to Home-Z
- Once Home-Z finishes, the DROs are all set to 0, with the carriage actually well into the build area, at [90,127,5]
- Operation was the same before the Dual-Extruder firmware was flashed.
- Previously attached Prusa I3 went to its specified Home position when Home-All was clicked.
- All three individual Home-?? buttons operate as expected, i.e. - no travel into the center of the build area.
- Pressing the individual Home-?? buttons in the order X, Y, Z leaves the bed at [0,245,5], as expected.
Initial connection log, plus M501 outputs are attached.
How do I get rid of this placement error?
TIA!