Repetier-HOST V1.0.6 - g-code view?

Repetier-HOST V1.0.6 - g-code view?

Postby Cloneit3d » 2014-Dec-Sun-21-Dec

I have a Simple Metal and when I am in manual mode using repetier host v1.0.6 I cannot find where I can view the commands that I enter. I know using older versions of Repetier this was not a problem as it was obvious. Using Cura it is also right there to see after you enter a command. I have been looking at the Repetier forum and the manual however I cannot seem to figure it out. I am hopeful it is an embarrassing oversight but I am missing it. I am running Win8.1

Thank you-
  • 0

CNC Plasma Cutter, own design
CNC Milling Machine
Printrbot Simple Metal with heated bed
2 other hopebuilt 3D printers
Cloneit3d
Loading filament...
 
Posts: 10
Joined: 2014-Dec-Wed-07-Dec
Reputation: 0

Repetier-HOST V1.0.6 - g-code view?

Sponsor

Sponsor
 

Re: Repetier-HOST V1.0.6 - g-code view?

Postby Cloneit3d » 2014-Dec-Sun-22-Dec

I got it - duh - toggle log - ok good laugh.
  • 0

CNC Plasma Cutter, own design
CNC Milling Machine
Printrbot Simple Metal with heated bed
2 other hopebuilt 3D printers
Cloneit3d
Loading filament...
 
Posts: 10
Joined: 2014-Dec-Wed-07-Dec
Reputation: 0


Return to Simple talk (software)

Who is online

Users browsing this forum: No registered users and 1 guest