Page 1 of 1

Ubis 13s vs e3d v6?

PostPosted: 2016-Feb-Fri-17-Feb
by sgibbers17
I'm thinking of getting a new hotend and see that the e3d v6 is highly recommended and the 13s is also a good upgrade for the ceramic ubis. But I am having a hard time finding someone directly comparing the two.

Re: Ubis 13s vs e3d v6?

PostPosted: 2016-Feb-Sat-05-Feb
by bbrown64
I went from the stock issue hotend directly to a E3D-V6. There is a bit more modding involved if you choose the V6. But from what I have read here in the forum. It is less troublesome than the new hotend from Printrbot.